| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/amd: Remove latent out-of-bounds access in IOMMU debugfs
In iommu_mmio_write() and iommu_capability_write(), the variables
dbg_mmio_offset and dbg_cap_offset are declared as int. However, they
are populated using kstrtou32_from_user(). If a user provides a
sufficiently large value, it can become a negative integer.
Prior to this patch, the AMD IOMMU debugfs implementation was already
protected by different mechanisms.
1. #define OFS_IN_SZ 8 ensures the user string <= 8 bytes, so
e.g. 0xffffffff isn't a valid input.
if (cnt > OFS_IN_SZ)
return -EINVAL;
2. Implicit type promotion in iommu_mmio_write(), dbg_mmio_offset is int
and iommu->mmio_phys_end is u64
if (dbg_mmio_offset > iommu->mmio_phys_end - sizeof(u64))
return -EINVAL;
3. The show handlers would currently catch the negative number and
refuse to perform the read.
Replace kstrtou32_from_user() with kstrtos32_from_user() to parse the
input, and check for negative values to explicitly prevent out-of-bounds
memory accesses directly in iommu_mmio_write() and
iommu_capability_write(). |
| A vulnerability in the Open Shortest Path First (OSPF) implementation of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper memory protection mechanisms while processing certain OSPF packets. An attacker could exploit this vulnerability by sending a series of malformed OSPF packets in a short period of time to an affected device. A successful exploit could allow the attacker to cause a reload of the affected device, resulting in a DoS condition for client traffic that is traversing the device. |
| In Eclipse OMR versions up to 0.11, the arraycmp SIMD implementation for Z and P does not check if the number of bytes to compare is zero. |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: stub: Reject I2C block transfers with invalid length
The I2C_SMBUS_I2C_BLOCK_DATA case in stub_xfer() uses data->block[0]
as the transfer length. The existing check only clamps it to avoid
overrunning the chip->words[256] register array, but does not validate
it against I2C_SMBUS_BLOCK_MAX (32), which is the limit of the union
i2c_smbus_data.block buffer (34 bytes total). The driver is a
development/test tool (CONFIG_I2C_STUB=m, not built by default)
that must be loaded with a chip_addr= parameter.
A local user with access to /dev/i2c-* can issue an I2C_SMBUS ioctl
with I2C_SMBUS_I2C_BLOCK_DATA and data->block[0] > 32, causing
stub_xfer() to read or write past the end of the union
i2c_smbus_data.block buffer:
BUG: KASAN: stack-out-of-bounds in stub_xfer (drivers/i2c/i2c-stub.c:223)
Read of size 1 at addr ffff88800abcfd92 by task exploit/81
Call Trace:
<TASK>
stub_xfer (drivers/i2c/i2c-stub.c:223)
__i2c_smbus_xfer (drivers/i2c/i2c-core-smbus.c:593)
i2c_smbus_xfer (drivers/i2c/i2c-core-smbus.c:536)
i2cdev_ioctl_smbus (drivers/i2c/i2c-dev.c:391)
i2cdev_ioctl (drivers/i2c/i2c-dev.c:478)
__x64_sys_ioctl (fs/ioctl.c:583)
do_syscall_64 (arch/x86/entry/syscall_64.c:94)
entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:130)
</TASK>
The bug exists because i2c-stub implements .smbus_xfer directly,
bypassing the I2C_SMBUS_BLOCK_MAX validation in
i2c_smbus_xfer_emulated(). The I2C_SMBUS_BLOCK_DATA case in the same
function correctly validates against I2C_SMBUS_BLOCK_MAX, but the
I2C_SMBUS_I2C_BLOCK_DATA case does not.
Fix by rejecting transfers with data->block[0] == 0 or
data->block[0] > I2C_SMBUS_BLOCK_MAX with -EINVAL, consistent with
both the I2C_SMBUS_BLOCK_DATA case in the same function and the
I2C_SMBUS_I2C_BLOCK_DATA validation in i2c_smbus_xfer_emulated(). |
| EIPStackGroup OpENer 2.3.0 (commit 76b95cf) has an out-of-bounds read issue in Connection Manager handling of ForwardOpen requests when processing short malformed packets. An attacker can send a valid ENIP outer frame carrying a malformed CIP ForwardOpen/LargeForwardOpen request, causing the parser to continue reading fields even when request data is insufficient. This issue is remotely triggerable via network traffic and does not require authentication. |
| OpENer 2.3.0 (commit 76b95cf) has an out-of-bounds read issue in CIP message parsing when handling malformed explicit requests with a forged EPath size. An attacker can send a valid ENIP SendRRData frame carrying a very short CIP payload whose path_size field claims that many more path words are present than are actually available. Because the parser trusts the attacker-controlled path_size and continues decoding path segments without a remaining-length boundary, it reads beyond the end of the stack receive buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Validate GPIO pin LUT table size before iterating
[Why&How]
The GPIO pin table parsers in get_gpio_i2c_info() and
bios_parser_get_gpio_pin_info() derive an element count from the VBIOS
table_header.structuresize field, then iterate over gpio_pin[] entries.
However, GET_IMAGE() only validates that the table header itself fits
within the BIOS image. If the VBIOS reports a structuresize larger than
the actual mapped data, the loop reads past the end of the BIOS image,
causing an out-of-bounds read.
Fix this by calling bios_get_image() to validate that the full claimed
structuresize is accessible within the BIOS image before entering the
loop in both functions.
(cherry picked from commit ba5e95b43b773ae1bf1f66ee6b31eb774e65afe3) |
| In the Linux kernel, the following vulnerability has been resolved:
fwctl: pds: Validate RPC input size before parsing
The fwctl core allocates the device-specific RPC input buffer with
fwctl_rpc.in_len and passes that buffer to the driver callback.
pdsfc_fw_rpc() casts the buffer to struct fwctl_rpc_pds and then calls
pdsfc_validate_rpc(), which reads fields from that structure before
checking that the input buffer is large enough to contain it. A short
in_len can make pds_fwctl read beyond the allocation.
Reject pds RPC buffers that are smaller than struct fwctl_rpc_pds before
parsing any pds-specific fields. |
| NGINX Plus and NGINX Open Source have a vulnerability in the ngx_http_charset_module module. When content is served or proxied through a location block with both source_charset utf-8; and a charset directive (for example, charset koi8-r;) configured, remote, unauthenticated attackers can send requests (in conjunction with conditions beyond their control) to cause a heap buffer over-read in the NGINX worker process, leading to limited disclosure of memory or a restart.
Note: Software versions which have reached End of Technical Support (EoTS) are not evaluated. |
| The UpdateHub OTA client in subsys/mgmt/updatehub/updatehub.c contains an out-of-bounds / uninitialized-memory read in z_impl_updatehub_probe(). The probe response from the UpdateHub server is copied into a heap buffer (metadata) that is correctly NUL-terminated, but a second buffer (metadata_copy) is allocated with k_malloc (unzeroed) and filled with memcpy(metadata_copy, metadata, strlen(metadata)), which omits the terminating NUL. Everything after the copied content remains uninitialized heap.
When the first json_obj_parse() over the array descriptor fails, the code falls back to json_obj_parse(metadata_copy, strlen(metadata_copy), ...). The strlen() call scans past the copied bytes through uninitialized heap and, if no zero byte is found before the end of the allocation, reads beyond the buffer; the resulting over-long length is then parsed as JSON. The probe payload is fully controlled by the (malicious, compromised, or — without the optional CONFIG_UPDATEHUB_DTLS — on-path) UpdateHub server, which can craft a large payload that fails the first parse to drive this path.
The consequence is a read of uninitialized heap, with a worst case of an out-of-bounds read past the metadata_copy allocation that can fault and crash the update thread/device, producing a network-triggerable denial of service. The over-read data is consumed only internally to evaluate the update and is not returned to the attacker, so there is no direct information disclosure and no out-of-bounds write.
The fix zeroes metadata_copy with memset before the copy, guaranteeing NUL termination and bounding strlen() within the allocation. |
| Buffer Over-read vulnerability in Apache HTTP Server via outbound OCSP requests to an attacker controlled OCSP server
This issue affects Apache HTTP Server: from 2.4.0 through 2.4.67.
Users are recommended to upgrade to version 2.4.68, which fixes the issue. |
| LIBPNG is a reference library for use in applications that read, create, and manipulate PNG (Portable Network Graphics) raster image files. Prior to 1.6.55, an out-of-bounds read vulnerability exists in the png_set_quantize() API function. When the function is called with no histogram and the number of colors in the palette is more than twice the maximum supported by the user's display, certain palettes will cause the function to enter into an infinite loop that reads past the end of an internal heap-allocated buffer. The images that trigger this vulnerability are valid per the PNG specification. This vulnerability is fixed in 1.6.55. |
| A race condition in OpenVPN 2.6.0 through 2.6.19 and 2.7_alpha1 through 2.7.1 allows remote attackers to potentially cause a server crash or leak heap memory via a use-after-free triggered during TLS session promotion. |
| gopacket provides packet processing capabilities for Go. Through version 1.7.0, multiple layer decoders use attacker-controlled lengths, counts, or offsets before validating them against packet buffers, allowing a crafted packet decoded through DecodingLayerParser or DecodeFromBytes to trigger an unrecovered panic and remotely deny service. A patch commit is available at 210f25f. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btusb: validate Realtek vendor event length
btusb_recv_event_realtek() reads the event code at data[0] and the Realtek
subevent code at data[2] before deciding whether to consume a vendor event
as a coredump.
For example, the two-byte event ff 00 contains a complete vendor-event
header declaring zero parameters. The old classifier still reads a
nonexistent third byte and can misclassify the event as a coredump if the
adjacent byte is 0x34.
Require the HCI event header and first parameter to be present before
inspecting the Realtek subevent code. Short events continue through the
normal HCI receive path, which owns their protocol validation. |
| Consul Community Edition and Consul Enterprise 1.18.21 through 2.0.2 are vulnerable to a partial arbitrary file read when configured to use the Vault Connect CA provider with JWT or AppRole authentication. A privileged attacker with `operator:write` permission may direct Consul to read and forward credential files outside the intended scope, potentially leading to the exfiltration of sensitive secrets from the Consul server host. This vulnerability, CVE-2026-19017, is fixed in Consul 2.0.3 and Consul Enterprise 1.21.17, 1.22.11, and 2.0.3. |
| The SF32LB MPI QSPI NOR flash driver (drivers/flash/flash_sf32lb_mpi_qspi_nor.c) validated the flash offset and length on its read and write paths with the test (offset + size) > data->size. Because offset is a signed off_t while size is unsigned, a negative offset is converted to a large unsigned value and the addition can wrap to a small result that passes the check. The read path then performs memcpy(dst, (void *)(data->base + offset), size) and the write path programs flash at offset and cache-invalidates data->base + offset, in both cases accessing memory outside the mapped flash window. The driver's erase path already rejected negative offsets, but read and write did not.
In builds with CONFIG_USERSPACE, flash_read and flash_write are syscalls whose verifiers validate the device object and the caller's buffer but deliberately delegate offset bounds checking to the driver. An unprivileged thread that has been granted access to this flash device can therefore call the syscall with a crafted negative offset and a buffer valid in its own memory domain, and reach the unchecked access.
The most direct impact is on the read path: by choosing a negative offset and matching size, an attacker slides the memcpy source below the flash base and copies arbitrary CPU-addressable memory into its own buffer, disclosing memory it is not authorized to read. The write path additionally allows programming flash at an out-of-range address and invalidating an attacker-chosen cache range, affecting integrity and availability. Reachability requires userspace to be enabled and the raw flash device object to be granted to an untrusted thread.
The fix replaces the check with qspi_nor_range_is_valid(), which rejects negative offsets and performs the bound comparison in overflow-safe 64-bit arithmetic on both paths, and additionally adds an SRAM DMA bounce buffer plus source/destination overlap rejection to prevent a separate DMA bus-hang condition. |
| Windows Network Address Translation (NAT) Denial of Service Vulnerability |
| Windows Network Address Translation (NAT) Denial of Service Vulnerability |
| Windows Wireless Wide Area Network Service (WwanSvc) Information Disclosure Vulnerability |
