| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: sxgbe: free TX rings on RX allocation failure
When RX descriptor ring allocation fails, init_dma_desc_rings() only
frees the partially allocated RX rings and returns. The TX rings that
were allocated earlier in the same function are leaked.
Rearrange error labels to clean up TX rings upon RX failures. |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: imx: mark I2C adapter when hardware is powered down
On some i.MX platforms, certain I2C client drivers keep a periodic
workqueue which continues to trigger I2C transfers.
During system suspend/resume, there exists a time window between:
- suspend_noirq and the system entering suspend
- the system starting to resume and resume_noirq
In this window, the I2C controller resources such as clock and pinctrl
may already be disabled or not yet restored.
If a workqueue triggers an I2C transfer in this period, the driver
attempts to access I2C registers while the hardware resources are
unavailable, which may lead to system hang.
Mark the I2C adapter as suspended during noirq suspend and block new
transfers until resume, ensuring that I2C transfers are only issued
when hardware resources are available. |
| In the Linux kernel, the following vulnerability has been resolved:
binfmt_misc: don't leak the user namespace when the mount fails
bm_get_tree() takes a reference to the user namespace and hands it to
get_tree_keyed() as the sget key. sget_fc() moves that reference into
sb->s_fs_info and clears fc->s_fs_info, so from that point on the
superblock owns it and bm_free() doesn't see it anymore.
The superblock drops it in ->put_super(). But generic_shutdown_super()
only calls ->put_super() from inside the if (sb->s_root) branch, so
nothing releases it when bm_fill_super() fails:
- The kzalloc_obj() failure leaves s_root NULL and the whole branch is
skipped.
- A simple_fill_super() failure in the file loop leaves s_root set, but
s_op still points at simple_super_operations, which has no
->put_super(). bm_fill_super() installs s_ops only once
simple_fill_super() returned success, and installing it earlier
wouldn't help either because simple_fill_super() overwrites s_op.
Either way vfs_get_super() calls deactivate_locked_super() and the
reference is gone for good. binfmt_misc mounts are available in a user
namespace and both the inode and the dentry cache are SLAB_ACCOUNT, so
an unprivileged caller under a tight memory cgroup can fail
simple_fill_super() on demand and leak one user namespace per attempt.
Drop the reference in ->kill_sb() instead, which runs unconditionally,
the same way nfsd and rpc_pipefs release their keyed s_fs_info.
That also stops ->put_super() from clearing s_fs_info while the
superblock is still on @fs_supers. generic_shutdown_super() leaves it
there on purpose so that sget_fc() keeps finding it until kill_sb() has
run, but a NULL s_fs_info makes test_keyed_super() miss it, so a
concurrent mount for the same user namespace skips the grab_super()
wait and creates a second superblock for a namespace that is still
being torn down. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: xhci: Prevent interrupt storm on host controller error (HCE)
The xHCI controller reports a Host Controller Error (HCE) in UAS Storage
Device plug/unplug scenarios on Android devices. HCE is checked in
xhci_irq() function and causes an interrupt storm (since the interrupt
isn’t cleared), leading to severe system-level faults.
When the xHC controller reports HCE in the interrupt handler, the driver
only logs a warning and assumes xHC activity will stop as stated in xHCI
specification. An interrupt storm does however continue on some hosts
even after HCE, and only ceases after manually disabling xHC interrupt
and stopping the controller by calling xhci_halt().
Add xhci_halt() to xhci_irq() function where STS_HCE status is checked,
mirroring the existing error handling pattern used for STS_FATAL errors.
This only fixes the interrupt storm. Proper HCE recovery requires resetting
and re-initializing the xHC. |
| In the Linux kernel, the following vulnerability has been resolved:
vxlan: mdb: Fix source list corruption on a failed replace
When replacing the source list of an MDB remote entry, all existing
sources are first marked for deletion and vxlan_mdb_remote_srcs_add()
is then called to add the new source list. Sources present in the new
list have their deletion mark cleared, and any sources left marked
afterwards are removed.
If vxlan_mdb_remote_srcs_add() fails partway through, its error path
deletes all entries on the remote's source list. That rollback is only
correct for its other caller, vxlan_mdb_remote_add(), where the remote
was just allocated and the list contains solely entries added during
the call. On the replace path the list also holds pre-existing sources,
so a failed replace tears them down together with their (S, G)
forwarding entries instead of leaving the entry unchanged.
This is reachable from an existing (*, G) remote. An EXCLUDE filter
that loses sources starts forwarding traffic that should be blocked,
while an INCLUDE filter that loses sources drops traffic that should be
forwarded.
Mark entries created during the current pass with a new
VXLAN_SGRP_F_NEW flag. On failure, delete only those entries and clear
the deletion mark on the pre-existing ones, so a failed replace leaves
the source list untouched. Retain the flag until the whole operation
succeeds and then clear it. Also stop vxlan_mdb_remote_src_add() from
deleting a pre-existing entry it only looked up when adding that
entry's forwarding entry fails. |
| A vulnerability in the TCP ingress handler for the data interfaces that are configured with management access to Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an increase in CPU and memory usage, resulting in a denial of service (DoS) condition. The vulnerability is due to insufficient ingress TCP rate limiting for TCP ports 22 (SSH) and 443 (HTTPS). An attacker could exploit this vulnerability by sending a crafted, steady stream of TCP traffic to port 22 or 443 on the data interfaces that are configured with management access to the affected device. |
| A vulnerability in the Internet Key Exchange version 1 (IKEv1) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition. The vulnerability is due to improper management of system memory. An attacker could exploit this vulnerability by sending malicious IKEv1 traffic to an affected device. A successful exploit could allow the attacker to cause a DoS condition on the affected device. |
| A vulnerability in the ARP packet processing of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, adjacent attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition on an affected device. The vulnerability is due to incorrect processing of ARP packets received by the management interface of an affected device. An attacker could exploit this vulnerability by sending a series of unicast ARP packets in a short timeframe that would reach the management interface of an affected device. A successful exploit could allow the attacker to consume resources on an affected device, which would prevent the device from sending internal system keepalives and eventually cause the device to reload, resulting in a denial of service (DoS) condition. |
| A vulnerability in the remote access SSL VPN features of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper validation of errors that are logged as a result of client connections that are made using remote access VPN. An attacker could exploit this vulnerability by sending crafted requests to an affected system. A successful exploit could allow the attacker to cause the affected device to restart, resulting in a DoS condition. |
| A vulnerability in the Snort rule evaluation function of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper handling of the DNS reputation enforcement rule. An attacker could exploit this vulnerability by sending crafted UDP packets through an affected device to force a buildup of UDP connections. A successful exploit could allow the attacker to cause traffic that is going through the affected device to be dropped, resulting in a DoS condition. Note: This vulnerability only affects Cisco FTD devices that are running Snort 3. |
| A vulnerability in the Internet Key Exchange version 1 (IKEv1) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper management of system memory. An attacker could exploit this vulnerability by sending malicious IKEv1 traffic to an affected device. The attacker does not need valid credentials to authenticate the VPN session, nor does the attacker's source address need to match a peer statement in the crypto map applied to the ingress interface of the affected device. An exploit could allow the attacker to exhaust system memory resources, leading to a reload of an affected device. |
| A vulnerability in the FTP inspection engine of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability exists because the affected software fails to release spinlocks when a device is running low on system memory, if the software is configured to apply FTP inspection and an access control rule to transit traffic, and the access control rule is associated with an FTP file policy. An attacker could exploit this vulnerability by sending a high rate of transit traffic through an affected device to cause a low-memory condition on the device. A successful exploit could allow the attacker to cause a software panic on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| Multiple vulnerabilities in the Application Layer Protocol Inspection feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerabilities are due to logical errors during traffic inspection. An attacker could exploit these vulnerabilities by sending a high volume of malicious traffic across an affected device. An exploit could allow the attacker to cause a deadlock condition, resulting in a reload of an affected device. These vulnerabilities affect Cisco ASA Software and Cisco FTD Software configured for Application Layer Protocol Inspection running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4100 Series Security Appliance, Firepower 9300 ASA Security Module, FTD Virtual (FTDv). Cisco Bug IDs: CSCve61540, CSCvh23085, CSCvh95456. |
| A vulnerability in how Cisco Firepower Threat Defense (FTD) Software handles session timeouts for management connections could allow an unauthenticated, remote attacker to cause a buildup of remote management connections to an affected device, which could result in a denial of service (DoS) condition. The vulnerability exists because the default session timeout period for specific to-the-box remote management connections is too long. An attacker could exploit this vulnerability by sending a large and sustained number of crafted remote management connections to an affected device, resulting in a buildup of those connections over time. A successful exploit could allow the attacker to cause the remote management interface or Cisco Firepower Device Manager (FDM) to stop responding and cause other management functions to go offline, resulting in a DoS condition. The user traffic that is flowing through the device would not be affected, and the DoS condition would be isolated to remote management only. |
| A vulnerability in the interaction between the TCP Intercept feature and the Snort 3 detection engine on Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured policies on an affected system. Devices that are configured with Snort 2 are not affected by this vulnerability.
This vulnerability is due to a logic error when handling embryonic (half-open) TCP connections. An attacker could exploit this vulnerability by sending a crafted traffic pattern through an affected device. A successful exploit could allow unintended traffic to enter the network protected by the affected device. |
| A vulnerability in the management web server of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker with high privileges to execute configuration commands on an affected system.
This vulnerability exists because access to HTTPS endpoints is not properly restricted on an affected device. An attacker could exploit this vulnerability by sending specific messages to the affected HTTPS handler. A successful exploit could allow the attacker to perform configuration changes on the affected system, which should be configured and managed only through Cisco Firepower Management Center (FMC) Software. |
| A vulnerability in the WebVPN service of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper management of authenticated sessions in the WebVPN portal. An attacker could exploit this vulnerability by authenticating with valid credentials and accessing a specific URL in the WebVPN portal. A successful exploit could allow the attacker to cause the device to reload, resulting in a temporary DoS condition. |
| A "Cisco Firepower Threat Defense 6.0.0 through 6.2.2 and Cisco ASA with FirePOWER Module Denial of Service" vulnerability in the access control policy of Cisco Firepower System Software could allow an authenticated, remote attacker to cause an affected system to stop inspecting and processing packets, resulting in a denial of service (DoS) condition. The vulnerability is due to improper SSL policy handling by the affected software when packets are passed through the sensing interfaces of an affected system. An attacker could exploit this vulnerability by sending crafted packets through a targeted system. This vulnerability affects Cisco Firepower System Software that is configured with the SSL policy feature. Cisco Bug IDs: CSCvc84361. |
| A vulnerability in the logging configuration of Secure Sockets Layer (SSL) policies for Cisco FirePOWER System Software 5.3.0 through 6.2.2 could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition due to high consumption of system resources. The vulnerability is due to the logging of certain TCP packets by the affected software. An attacker could exploit this vulnerability by sending a flood of crafted TCP packets to an affected device. A successful exploit could allow the attacker to cause a DoS condition. The success of an exploit is dependent on how an administrator has configured logging for SSL policies for a device. This vulnerability affects Cisco FirePOWER System Software that is configured to log connections by using SSL policy default actions. Cisco Bug IDs: CSCvd07072. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix root leak if its reloc root is unexpected in merge_reloc_roots()
If we have an unexpected reloc_root for our root, we jump to the out label
but never drop the reference we obtained for root, resulting in a leak.
Add a missing btrfs_put_root() call. |
