| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: libiscsi: Fix stale-data leak into the SCSI sense buffer
iscsi_scsi_cmd_rsp() copies the sense data of a SCSI Response from the
target-supplied data segment. The segment carries a 2-byte sense length
followed by the sense bytes, so it must hold 2 + senselen bytes, but the
bounds check only requires datalen >= senselen:
senselen = get_unaligned_be16(data);
if (datalen < senselen)
goto invalid_datalen;
memcpy(sc->sense_buffer, data + 2,
min_t(uint16_t, senselen, SCSI_SENSE_BUFFERSIZE));
A target that returns a SCSI Response whose datalen equals senselen
(with senselen <= SCSI_SENSE_BUFFERSIZE) makes the memcpy() from data +
2 read up to two bytes past the received data. Those bytes are stale
conn->data contents and end up in the command's sense buffer, which is
returned to userspace.
Account for the 2-byte sense length prefix in the check. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: fix uint32_t overflow in EOP ring buffer size alignment
eop_ring_buffer_size in struct queue_properties is a u32. In
kfd_queue_acquire_buffers() the expected EOP buffer size is computed as
ALIGN(eop_ring_buffer_size, PAGE_SIZE); ALIGN uses typeof(x), so the
addition is done in 32-bit. A user-supplied size of 0xFFFFF001 wraps to
0, causing kfd_queue_buffer_get() to skip its exact-size check (gated on
size != 0) and accept any BO mapped at the address. On GFX8/GFX9 the MQD
cp_hqd_eop_control is then programmed for an 8KB EOP ring backed by a 4KB
BO, so CP EOP writes can land past the buffer and fault the GPU.
Cast the operand to u64 so the alignment is computed in 64-bit; the size
check in kfd_queue_buffer_get() then rejects the oversized request.
(cherry picked from commit ae443117b742c357bfef3a7bddabf76fcf86e9ef) |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: ccp - Fix snp_filter_reserved_mem_regions() off-by-one
Sashiko notes:
> regarding the bounds check in snp_filter_reserved_mem_regions()
> called via walk_iomem_res_desc(): does the check
> if ((range_list->num_elements * 16 + 8) > PAGE_SIZE)
> allow an off-by-one heap buffer overflow?
>
> If range_list->num_elements is 255, 255 * 16 + 8 = 4088, which is <= 4096.
> Writing range->base (8 bytes) fills 4088-4095, but writing range->page_count
> (4 bytes) would write to 4096-4099, overflowing the kzalloc-allocated
> PAGE_SIZE buffer.
Fix this by accounting for the entry about to be written to, in addition to
the entries that are already allocated. |
| In the Linux kernel, the following vulnerability has been resolved:
sctp: validate embedded address parameter length
sctp_verify_asconf() and sctp_verify_param() only validate ADD_IP, DEL_IP,
and SET_PRIMARY parameters against a fixed minimum size of sizeof(struct
sctp_addip_param) + sizeof(struct sctp_paramhdr). This ensures the outer
parameter is large enough to contain an embedded address parameter header,
but does not verify that the embedded address parameter's declared length
fits within the bounds of the outer parameter.
Later, sctp_process_param() and sctp_process_asconf_param() extract the
embedded address parameter and pass it to af->from_addr_param(), which uses
the address parameter length to parse the variable-length address payload.
A malformed peer can therefore advertise an embedded address parameter
length that exceeds the remaining bytes in the enclosing parameter.
Validate that addr_param->p.length does not exceed the space available
after the sctp_addip_param header before processing the embedded address
parameter. Reject malformed parameters when the embedded address length
extends beyond the enclosing parameter bounds.
This prevents out-of-bounds reads when parsing malformed parameters carried
in INIT or ASCONF processing paths. |
| A vulnerability was detected in Open Asset Import Library Assimp 17c12da. This affects the function Assimp::MDLImporter::AddBonesToNodeGraph_3DGS_MDL7 of the file code/AssetLib/MDL/MDLLoader.cpp of the component Node Parser. The manipulation of the argument bones_num results in heap-based buffer overflow. The attack can be executed remotely. The exploit is now public and may be used. The project was informed of the problem early through an issue report but has not responded yet. |
| A security vulnerability has been detected in Open Asset Import Library Assimp 17c12da. The impacted element is the function Assimp::MDLImporter::GenerateOutputMeshes_3DGS_MDL7 of the file code/AssetLib/MDL/MDLLoader.cpp of the component 3DGS MDL7 Model Output Mesh Generator. The manipulation leads to buffer overflow. Remote exploitation of the attack is possible. The exploit has been disclosed publicly and may be used. The project was informed of the problem early through an issue report but has not responded yet. |
| A weakness has been identified in Edimax EW-7478APC 1.04. This affects the function formWanTcpipSetup of the file /goform/formWanTcpipSetup. This manipulation of the argument pppUserName causes stack-based buffer overflow. Remote exploitation of the attack is possible. The exploit has been made available to the public and could be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was detected in TrailDB 0.6. Impacted is the function tdb_open of the file /src/tdb.c of the component TOC Validation. The manipulation results in out-of-bounds read. It is possible to launch the attack remotely. The exploit is now public and may be used. The project was informed of the problem early through an issue report but has not responded yet. |
| A weakness has been identified in DefaultFuction Customer-Relationship-Management-In-C-Project 2.0. Impacted is the function gets of the component Customer Search Module. This manipulation causes stack-based buffer overflow. The attack may be initiated remotely. The exploit has been made available to the public and could be used for attacks. The project confirms, that "it’s being processed". |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: validate skb length in testmode query
In mt7925_tm_query(), the response skb from mt76_mcu_send_and_get_msg()
is used in a memcpy without validating its length:
memcpy(evt_resp, skb->data + 8, MT7925_EVT_RSP_LEN);
where MT7925_EVT_RSP_LEN is 512. If the firmware returns a response
shorter than 520 bytes (8 + 512), this reads beyond the skb data
buffer. The over-read data is then returned to userspace via nla_put()
in mt7925_testmode_dump().
Add a length check before the memcpy to ensure the skb contains
sufficient data. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/irdma: Fix OOB read during CQ MR registration
Sashiko pointed out an unrelated bug during a previous patch:
https://sashiko.dev/#/patchset/20260512183852.614045-1-jmoroni%40google.com
This change fixes the bug by eliminating the cqmr->split field which
was not being set properly and instead just checks the CQ resize
feature flag directly.
The cqmr->split field essentially tracks whether IRDMA_FEATURE_CQ_RESIZE
is set, but it was not being set until CQ creation time, which is _after_
CQ memory registration (the only other place where it is referenced).
As a result, it would always be false during MR registration and would
therefore cause irdma_handle_q_mem to populate cqmr->shadow even for GEN_2
HW and beyond:
cqmr->shadow = (dma_addr_t)arr[req->cq_pages];
The issue is that for GEN_2 and beyond, req->cq_pages may be exactly equal
to iwmr->page_cnt and therefore equal to the size of arr, which would cause
an OOB read by one. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: sm501fb: Fix buffer errors in OF binding code
The code that gets the frame buffer mode from OF has 'use after free',
'buffer overrun' and memory leaks.
info->edid_data isn't free if the probe functions fail or if
pd->def_mode is set.
If both the CRT and PANEL are enabled info->edid_data is used after
being freed and is freed twice.
The string returned by of_get_property(np, "mode", &len) is just
written over either the static "640x480-16@60" or the module parameter
string without any regard for the length (which is most likely longer).
Use kstrump() for the OF mode and free everything before freeing 'info. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: bound S1G TIM PVB walk to the TIM element
ieee80211_s1g_check_tim() parses the S1G Partial Virtual Bitmap (PVB) of a
received TIM element. The TIM is handed in as the element payload:
ieee802_11_parse_elems_full() stores elems->tim = elem->data and
elems->tim_len = elem->datalen (net/mac80211/parse.c), so the valid bytes
are [tim, tim + tim_len).
When walking the encoded blocks the function passes the walker an end
sentinel of (const u8 *)tim + tim_len + 2, i.e. two bytes past the end of
the element. ieee80211_s1g_find_target_block() loops while (ptr + 1 <= end)
and dereferences ptr (and the per-mode ieee80211_s1g_len_*() helpers read
*ptr), so it can read up to two bytes beyond the TIM element -- an
out-of-bounds read of adjacent skb/heap data when the TIM is the last
element in the frame. The +2 appears to account for the element id/len
header, but tim already points past that header at the element payload, so
the addend is wrong.
Pass the correct element end, (const u8 *)tim + tim_len. |
| In the Linux kernel, the following vulnerability has been resolved:
xsk: drain continuation descs after overflow in xsk_build_skb()
Fix generic xmit path multi-buffer logic when packets are either too big
(count of descriptors exceed MAX_SKB_FRAGS) or an invalid descriptor is
included in fragmented packet. Introduce xdp_sock::drain_cont and act
upon this flag - when it is set, keep on consuming descriptors from
AF_XDP Tx ring and put them directly onto Cq. Previously these
descriptors were silently lost and could never be reached again. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: Validate length before parsing diagnostics TLV
btintel_diagnostics() accesses tlv->val[0] without first validating
that the diagnostics VSE is long enough to contain that field, so
may cause reading data beyond the received frame.
Fix by validating the length before access. |
| In the Linux kernel, the following vulnerability has been resolved:
can: peak_usb: validate uCAN receive record lengths
pcan_usb_fd_decode_buf() walks uCAN records packed in one USB
receive buffer.
Require each record to contain the fixed header for its type, and verify
CAN payload bytes before copying them into the skb. |
| In the Linux kernel, the following vulnerability has been resolved:
can: kvaser_usb_leaf: kvaser_usb_leaf_wait_cmd(): validate received command extents
The wait and bulk receive paths walk variable-length commands from a
USB buffer. A nonzero command shorter than CMD_HEADER_LEN can still be
dispatched, and the wait path copies a matching command into a fixed
caller-owned struct kvaser_cmd using the device-provided length.
Reject nonzero commands that do not contain the fixed header or that
extend beyond the current USB buffer item. In the wait path, also reject
a matching command that exceeds the destination before copying it. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Bound synthetic-field strings with seq_buf
The synthetic field helpers build a prefixed synthetic variable name and
a generated hist command in fixed MAX_FILTER_STR_VAL buffers. The
current code appends those strings with raw strcat(), so long key lists,
field names, or saved filters can run past the end of the staging
buffers.
Build both strings with seq_buf and propagate -E2BIG if either the
synthetic variable name or the generated command exceeds
MAX_FILTER_STR_VAL. This keeps the existing tracing-side limit while
using the helper intended for bounded command construction.
[ sdr: Moved struct seq_buf *s for upside-down x-mas tree formatting ] |
| In the Linux kernel, the following vulnerability has been resolved:
power: supply: core: fix supplied_from allocations
If dts property power-supplies has multiple values, then accessing to
psy->supplied_from[i-1] in __power_supply_populate_supplied_from will
overrun supplied_from array. |
| As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco IOS XE Software engineering team has conducted a comprehensive internal security review. This review resulted in software hardening releases that address multiple internally discovered vulnerabilities.
The vulnerabilities tracked by CVE-2026-20268 are related to issues with improper restriction of operations within the bounds of a memory buffer that are grouped under the Common Weakness Enumeration (CWE) Pillar CWE-119. |
