| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Issue summary: When CMS password-based decryption (RFC 3211 / PWRI key unwrap)
processes attacker-supplied CMS data, an attacker-chosen stream-mode KEK
cipher can trigger a heap out-of-bounds read in kek_unwrap_key().
Impact summary: A heap buffer over-read may trigger a crash which leads to
Denial of Service for an application if the input buffer ends at a memory
page boundary and the following page is unmapped. There is no information
disclosure as the over-read bytes are not revealed to the attacker.
The key unwrapping function performs a check-byte test as specified in the
RFC that reads 7 bytes from a heap allocation that is based on the wrapped
key length from the message. There is a minimum length check based on the
block length of the wrapping cipher. However the cipher is selected from
an OID carried in the attacker's PWRI keyEncryptionAlgorithm with no
requirement that the cipher be a block cipher. When an attacker selects
a stream-mode cipher the guard will be ineffective and the allocated buffer
containing the unwrapped key can be too small to fit the check-bytes
specified in the RFC and a buffer over-read can happen.
Applications calling CMS_decrypt() or CMS_decrypt_set1_password()
(equivalently openssl cms -decrypt -pwri_password ...) on untrusted CMS
data are vulnerable to this issue. No password knowledge is required: the
over-read happens during the unwrap attempt before any authentication
succeeds.
The over-read is limited to a few bytes and is not written to output, so
there is no information disclosure. Triggering a crash requires the
allocation to border unmapped memory, which is unlikely with the normal
allocator.
The FIPS modules are not affected by this issue. |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to versions 6.9.13-48 and 7.1.2-23, when using LZMA compression in the MIFF encoder an out of bounds write can occur due to a missing check. This issue has been patched in versions 6.9.13-48 and 7.1.2-23. |
| lldpd is an implementation of IEEE 802.1ab (LLDP). Prior to version 1.0.22, lldpd_decode() in src/daemon/lldpd.c strips 802.1Q VLAN tags from received Ethernet frames by calling memmove() to shift the frame payload 4 bytes left. The third argument (byte count) is s - 2 * ETHER_ADDR_LEN but should be s - 2 * ETHER_ADDR_LEN - 4, causing a 4-byte heap buffer over-read past the malloc(h_mtu) allocation when the received frame size equals the interface MTU. This issue has been patched in version 1.0.22. |
| GIMP HDR File Parsing Heap-based Buffer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of GIMP. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of HDR files. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a heap-based buffer. An attacker can leverage this vulnerability to execute code in the context of the current process. Was ZDI-CAN-28618. |
| In the Linux kernel, the following vulnerability has been resolved:
media: rc: xbox_remote: heed DMA restrictions
The buffer for IO must not be part of the device structure
because that violates the DMA coherency rules. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Add bounds checking to ib_{get,set}_value
The uvd/vce/vcn code accesses the IB at predefined offsets without
checking that the IB is large enough. Check the bounds here. The caller
is responsible for making sure it can handle arbitrary return values.
Also make the idx a uint32_t to prevent overflows causing the condition
to fail. |
| FreeSWITCH is a Software Defined Telecom Stack enabling the digital transformation from proprietary telecom switches to a software implementation that runs on any commodity hardware. Prior to version 1.11.1, the mod_verto HTTP request handler allocates a fixed 2 MiB buffer for a POST application/x-www-form-urlencoded body but accepts Content-Length up to just under 10 MiB. The body-read loop is bounded by Content-Length rather than the buffer size, producing an attacker-controlled heap overflow of up to ~8 MiB -- before the HTTP basic-auth check runs. This issue has been patched in version 1.11.1. |
| Heap buffer overflow in Video in Google Chrome prior to 149.0.7827.53 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| In the Linux kernel, the following vulnerability has been resolved:
clk: microchip: mpfs-ccc: fix out of bounds access during output registration
UBSAN reported an out of bounds access during registration of the last
two outputs. This out of bounds access occurs because space is only
allocated in the hws array for two PLLs and the four output dividers
that each has, but the defined IDs contain two DLLS and their two
outputs each, which are not supported by the driver. The ID order is
PLLs -> DLLs -> PLL outputs -> DLL outputs. Decrement the PLL output IDs
by two while adding them to the array to avoid the problem. |
| Incorrect boundary conditions in the Graphics: Text component. This vulnerability was fixed in Firefox 151.0.3. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. Prior to 3.26.0, a malicious RDP client can trigger a heap-buffer-overflow write in FreeRDP's server-side clipboard (cliprdr) channel by sending a CB_CLIP_CAPS PDU with a too-small capabilitySetLength. This can crash the server process (remote DoS) and may be exploitable for code execution because it corrupts heap memory. This vulnerability is fixed in 3.26.0. |
| Heap buffer overflow in ANGLE in Google Chrome prior to 148.0.7778.216 allowed a remote attacker to potentially exploit heap corruption via a crafted HTML page. (Chromium security severity: High) |
| In the Linux kernel, the following vulnerability has been resolved:
libceph: Fix slab-out-of-bounds access in auth message processing
If a (potentially corrupted) message of type CEPH_MSG_AUTH_REPLY
contains a positive value in its result field, it is treated as an
error code by ceph_handle_auth_reply() and returned to
handle_auth_reply(). Thereafter, an attempt is made to send the
preallocated message of type CEPH_MSG_AUTH, where the returned value is
interpreted as the size of the front segment to send. If the result
value in the message is greater than the size of the memory buffer
allocated for the front segment, an out-of-bounds access occurs, and
the content of the memory region beyond this buffer is sent out.
This patch fixes the issue by treating only negative values in the
result field as errors. Positive values are therefore treated as success
in the same way as a zero value. Additionally, a BUG_ON is added to
__send_prepared_auth_request() comparing the len parameter to
front_alloc_len to prevent sending the message if it exceeds the bounds
of the allocation and to make it easier to catch any logic flaws leading
to this. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: rpl: reserve mac_len headroom when recompressed SRH grows
ipv6_rpl_srh_rcv() decompresses an RFC 6554 Source Routing Header, swaps
the next segment into ipv6_hdr->daddr, recompresses, then pulls the old
header and pushes the new one plus the IPv6 header back. The
recompressed header can be larger than the received one when the swap
reduces the common-prefix length the segments share with daddr (CmprI=0,
CmprE>0, seg[0][0] != daddr[0] gives the maximum +8 bytes).
pskb_expand_head() was gated on segments_left == 0, so on earlier
segments the push consumed unchecked headroom. Once skb_push() leaves
fewer than skb->mac_len bytes in front of data,
skb_mac_header_rebuild()'s call to:
skb_set_mac_header(skb, -skb->mac_len);
will store (data - head) - mac_len into the u16 mac_header field, which
wraps to ~65530, and the following memmove() writes mac_len bytes ~64KiB
past skb->head.
A single AF_INET6/SOCK_RAW/IPV6_HDRINCL packet over lo with a two
segment type-3 SRH (CmprI=0, CmprE=15) reaches headroom 8 after one
pass; KASAN reports a 14-byte OOB write in ipv6_rthdr_rcv.
Fix this by expanding the head whenever the remaining room is less than
the push size plus mac_len, and request that much extra so the rebuilt
MAC header fits afterwards. |
| In the Linux kernel, the following vulnerability has been resolved:
xsk: tighten UMEM headroom validation to account for tailroom and min frame
The current headroom validation in xdp_umem_reg() could leave us with
insufficient space dedicated to even receive minimum-sized ethernet
frame. Furthermore if multi-buffer would come to play then
skb_shared_info stored at the end of XSK frame would be corrupted.
HW typically works with 128-aligned sizes so let us provide this value
as bare minimum.
Multi-buffer setting is known later in the configuration process so
besides accounting for 128 bytes, let us also take care of tailroom space
upfront. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: proc: size address buffers for %pISpc output
The AF_RXRPC procfs helpers format local and remote socket addresses into
fixed 50-byte stack buffers with "%pISpc".
That is too small for the longest current-tree IPv6-with-port form the
formatter can produce. In lib/vsprintf.c, the compressed IPv6 path uses a
dotted-quad tail not only for v4mapped addresses, but also for ISATAP
addresses via ipv6_addr_is_isatap().
As a result, a case such as
[ffff:ffff:ffff:ffff:0:5efe:255.255.255.255]:65535
is possible with the current formatter. That is 50 visible characters, so
51 bytes including the trailing NUL, which does not fit in the existing
char[50] buffers used by net/rxrpc/proc.c.
Size the buffers from the formatter's maximum textual form and switch the
call sites to scnprintf().
Changes since v1:
- correct the changelog to cite the actual maximum current-tree case
explicitly
- frame the proof around the ISATAP formatting path instead of the earlier
mapped-v4 example |
| A security flaw has been discovered in Assimp up to 6.0.4. Affected is the function HL1MDLLoader::extract_anim_value of the file HL1MDLLoader.cpp of the component Half-Life 1 MDL Loader. Performing a manipulation of the argument num.total results in heap-based buffer overflow. The attack must be initiated from a local position. The exploit has been released to the public and may be used for attacks. The project tagged the reported issue as bug. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: mpt3sas: Limit NVMe request size to 2 MiB
The HBA firmware reports NVMe MDTS values based on the underlying drive
capability. However, because the driver allocates a fixed 4K buffer for
the PRP list, accommodating at most 512 entries, the driver supports a
maximum I/O transfer size of 2 MiB.
Limit max_hw_sectors to the smaller of the reported MDTS and the 2 MiB
driver limit to prevent issuing oversized I/O that may lead to a kernel
oops. |
| In the Linux kernel, the following vulnerability has been resolved:
accel/amdxdna: Fix out-of-bounds memset in command slot handling
The remaining space in a command slot may be smaller than the size of
the command header. Clearing the command header with memset() before
verifying the available slot space can result in an out-of-bounds write
and memory corruption.
Fix this by moving the memset() call after the size validation. |
| In the Linux kernel, the following vulnerability has been resolved:
efi: Fix reservation of unaccepted memory table
The reserve_unaccepted() function incorrectly calculates the size of the
memblock reservation for the unaccepted memory table. It aligns the
size of the table, but fails to account for cases where the table's
starting physical address (efi.unaccepted) is not page-aligned.
If the table starts at an offset within a page and its end crosses into
a subsequent page that the aligned size does not cover, the end of the
table will not be reserved. This can lead to the table being overwritten
or inaccessible, causing a kernel panic in accept_memory().
This issue was observed when starting Intel TDX VMs with specific memory
sizes (e.g., > 64GB).
Fix this by calculating the end address first (including the unaligned
start) and then aligning it up, ensuring the entire range is covered
by the reservation. |
